Remove 2005 Remove Ceiling Systems Remove Plumbing Systems
article thumbnail

The Complete Guide for Moving Into a New Build

UK Construction Blog

A good surveyor will inspect everything from internal walls and doors to plumbing, electrics, loft insulation, and more — identifying problems that might otherwise go unnoticed. While things may still be drying out and adjusting, this is the ideal time to tick off some important admin, check systems, and lay the groundwork for a smooth start.

article thumbnail

Revit OpEd: View Discipline

Revit OpEd

When MEP (Systems as it was called then) appeared a year later they extended the concept to Mechanical and Electrical (plumbing lumped in with Mechanical till release 2013). Plumbing - (new to 2013) Same as mechanical. So is it possible to show the ceiling grid and have the air terminal families show below the duct?

Insiders

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

article thumbnail

Revit OpEd: Column Shading Gets Obstinate

Revit OpEd

I suspect that the angle column settings "rotate" the "shading" out of plumb and then the columns lose the ability to do it anymore. Much like annotation graphics in lighting fixtures wont show up on sloped ceilings, just the 3D geometry. ► 2005. (73). ► December 2005. (7). ► November 2005. (14).

article thumbnail

Open information exchange of Heating, Ventilating and Cooling systems (HVAC) – A Important Standard? – HVAC information exchange – HVACie

Building Information Management

Open information exchange of Heating, Ventilating and Cooling systems (HVACie), released by the Engineer Research and Development Center for public review. HVACie extends the existing Industry Foundation Class Coordination View including equipment and system information streamlining construction shop drawing and fabrication.

article thumbnail

Open information exchange of Heating, Ventilating and Cooling systems (HVAC) – A Important Standard? – HVAC information exchange – HVACie

Building Information Management

Open information exchange of Heating, Ventilating and Cooling systems (HVACie), released by the Engineer Research and Development Center for public review. HVACie extends the existing Industry Foundation Class Coordination View including equipment and system information streamlining construction shop drawing and fabrication.

article thumbnail

Facilities Maintenance Checklist and Procedures

Job Order Contracting

Application: This standard applies to all installed sprinkler systems with nozzles. This work should be scheduled prior to flushing system. Application: This standard applies to all installed flag poles with electric and manual cabling systems. Review manufacturer’s instructions for all system components. Check Points: 1.

article thumbnail

Public Law 111-308 – Federal Buildings Personnel Training Act – FBPTA – CORE COMPETENCIES

Building Information Management

Reviewers admired the system’s three levels of increasing knowledge, skills and abilities as a “concept”, but did not believe it was implementable government-­?wide. Sys tem Des ign: We developed a system that focused on the highest impact core competencies common to every agency -­? Oppor tunity: The web-­?tool