article thumbnail

Precast Concrete Lintels: The Ultimate Guide to Strength, Durability & Installation

UK Construction Blog

The post Precast Concrete Lintels: The Ultimate Guide to Strength, Durability & Installation appeared first on UK Construction Blog. Installation requires precise techniques including a minimum 150mm end bearing on each side, proper alignment for cavity walls, and temporary supports for longer spans to ensure structural integrity.

article thumbnail

Refine versus shine: Defining and defending design intent with refined concrete

Construction Specifier

LEED AP, Vivian Volz, CSI, AIA, LEED AP, SCIP Photo courtesy Tao Group Solutions After years of grappling with client callbacks, legal disputes, and financial losses from poor polished concrete installations, the industry has reached a breaking point: prohibit polished concrete. The top 19 to 25 mm (0.75

Insiders

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

article thumbnail

No Pressure: How Will JCoP Help Construction Companies Keep Their Water Locked Away?

UK Construction Blog

Dan Simmons, Managing Director and founder, Quensus If insurers were asked to rank what they see as the most costly damages they could incur, you would expect factors like weather, fire and theft to sit high up the table. This system enables automatic water flow monitoring and the ability to shut off the supply.

article thumbnail

Professional Epoxy Flooring in Manchester: Durable Solutions for Every Space

UK Construction Blog

Professional Manchester epoxy floor contractors bring over 40 years of experience, ensuring flawless installations with minimal disruption even in high-traffic environments like the University of Manchester and Arndale Centre.

article thumbnail

The Los Angeles County Museum of Art: Enormous Complexity Under a Veil of Simplicity

ENR Construction

The building can move 5 ft laterally in any direction thanks to a state-of-the-art seismic protection system with 56 base isolators. The team went on to install 400 more piles, 240 micropiles and 40 continuous flight auger piles. “Had we waited, the project would today be 20-30% more expensive,” Vesga says.

article thumbnail

APPLYING SPRAY FOAM INSULATION ON AND AROUND PLASTIC PIPES

Civil + Structural Engineer

PPI and SPFA recommend that when there are plastic pipes and fittings in a wall, ceiling, or floor cavity, the SPF installer should apply one layer of foam until it touches the pipe but does not encase the pipe. In certain instances, pipes and fittings are installed inside areas that must be insulated, such as within a ceiling or wall cavity.

article thumbnail

Comparing Liquid and Sheet-applied Bridge Deck Waterproofing Membranes

GCP Applied Technologies

Years ago, engineers had little choice but to use sheet-applied waterproofing for protecting bridge decks. With high performing liquid-applied waterproofing, this concern is removed because the system cures to form a monolithic and fully bonded membrane to prevent water penetration and migration. Phillip.fry@gc….