CivilJungle

FEBRUARY 28, 2021

What Are Defects in Painting? Painting is one of the important finishing works used in structural constructions in Civil Engineering. Painting creates a coat-like formation that prevents attacks from various atmospheric factors like cold, heat, frost, rainfall, etc. Types of Defects in Painting. Brush Marks.

Painting/finishing 52

Painting/finishing Wall Systems Foundation Systems Flooring Systems 52

ENR Construction

JUNE 16, 2025

National Park system would come with its own unique set of challenges. Rising 180 ft above the river gorge, the four-span steel plate girder bridge will replace the existing structure, which was built in 1961 and is located just 700 ft to the southeast. The nearly 600 precast deck panels from Plumb Creek Structures in Littleton, Colo.,

Concrete Pouring 68

Concrete Pouring Steel Fabrication Site Planning Surveying 68

Construction Specifier

SEPTEMBER 4, 2024

Concrete floor quality depends on several factors, including the concrete mix design, the curing process, including consolidation and finishing. Floor levelness is essential for various applications, such as building foundations, where a level floor ensures the load is evenly distributed and the structure remains stable.

Building Performance Measurement 82

Building Performance Measurement Curing Concrete Pouring Flooring Systems 82

GCP Applied Technologies

MARCH 21, 2018

According to a recent study by Allied Market Research, the demand for greater energy efficiency and faster construction is driving an increase in the use of precast concrete systems. Precast concrete is often used to create structural systems (columns, beams, floors, girders, etc.), Structural Solutions. Concera Blog #19.

Cost Control 104

Cost Control Structural Systems Building Controls Flooring Systems 104

GCP Applied Technologies

MARCH 21, 2018

Steel/concrete core wall system. This system uses two steel plates that are connected by steel spacing ties, with the cavity then filled with high strength concrete. This system eliminates the need for rebar and formwork. In addition, it’s safer for the concrete finishers, because it readily flows and requires less vibration.

Wall Systems 95

Wall Systems Building Controls Ceiling Systems Structural Systems 95

GCP Applied Technologies

JUNE 7, 2018

Waterproofing Membranes for Below Grade Structures. Waterproofing Membranes for Below Grade Structures. Waterproofing Below Grade Structures. Water infiltration can cause problems by corroding the structure and damaging materials housed within the building. Dewatering system. Phillip.fry@gc…. September 17, 2018.

Waterproofing Systems 103

Waterproofing Systems Concrete Pouring Structural Systems Foundation Systems 103

GCP Applied Technologies

MARCH 21, 2018

Steel/concrete core wall system. This system uses two steel plates that are connected by steel spacing ties, with the cavity then filled with high strength concrete. This system eliminates the need for rebar and formwork. In addition, it’s safer for the concrete finishers, because it readily flows and requires less vibration.

Wall Systems 90

Wall Systems Building Controls Ceiling Systems Structural Systems 90

GCP Applied Technologies

MAY 28, 2018

Waterproofing protects your structure and the assets within it against damaging moisture, humidity, and floods. Although waterproofing systems account for a small fraction of the cost of an overall building project, if the wrong solution is chosen or it’s installed improperly, the costs of remediation can be tremendous. . May 28, 2018.

Waterproofing Systems 113

Waterproofing Systems Concrete Pouring Structural Systems Wall Systems 113

CCR Magazine

JANUARY 24, 2025

Whether its a charming old Victorian house or a sleek, modern office tower, every structure needs a little TLC to keep things running smoothly. The thing is, most people dont think about maintenance until something goes wronga pipe bursts, the elevator quits, or the HVAC system turns into a glorified fan. Win-win, right?

Maintenance 52

Maintenance Property Management HVAC Systems Roofing Systems 52

UK Construction Blog

APRIL 2, 2025

Professional installation follows a systematic process of thorough surface preparation and precise application techniques, with costs ranging from 20-150 per square metre depending on the chosen finish. Safety features make epoxy particularly valuable in industrial settings.

Flooring Systems 52

Flooring Systems Heavy Equipment Manufacturing Concrete Pouring Painting/finishing 52

GCP Applied Technologies

MAY 28, 2018

Waterproofing protects your structure and the assets within it against damaging moisture, humidity, and floods. Although waterproofing systems account for a small fraction of the cost of an overall building project, if the wrong solution is chosen or it’s installed improperly, the costs of remediation can be tremendous. . May 28, 2018.

Waterproofing Systems 104

Waterproofing Systems Concrete Pouring Structural Systems Wall Systems 104

Construction Specifier

APRIL 9, 2025

percent embodied carbon savings compared to the regional industry average 28-day standard-cured compressive strength, rising to as much as 68 percent with specific applications in the building. With the strategic selection of project areas for a 56-day curing schedule, the team was able to minimize impacts on the construction time and cost.

Energy Efficiency 59

Energy Efficiency Green Building Renewable Energy Systems Building Design 59

Commercial Construction Blog

JUNE 26, 2018

For this Hard Hat Chat post, we thought we’d take a look back at this retail construction project and share photos from the finished space and behind-the-scenes details about the construction process, which was completed in November 2017. Grand Entrances (And Tight Squeezes). Instead, we had to use regular entrances.

Flooring Systems 90

Flooring Systems Millwork Curing Painting/finishing 90

GCP Applied Technologies

FEBRUARY 19, 2020

Manage concrete batches with a truck-mounted system. Concrete producers are well aware of the difficulty of delivering, handling, placing, finishing and curing concrete, especially during the hot summer months. Manage concrete batches with a truck-mounted system. Structural Solutions. Reduce concrete cracking.

Structural Systems 78

Structural Systems Facility Management Material Handling Building Optimization 78

GCP Applied Technologies

FEBRUARY 19, 2020

Manage concrete batches with a truck-mounted system. Concrete producers are well aware of the difficulty of delivering, handling, placing, finishing and curing concrete, especially during the hot summer months. Manage concrete batches with a truck-mounted system. Structural Solutions. Reduce concrete cracking.

Structural Systems 78

Structural Systems Facility Management Material Handling Building Optimization 78

GCP Applied Technologies

OCTOBER 1, 2018

Air entraining agents (AEA) are used to entrain air in concrete when a structure will be exposed to moisture, freeze thaw cycles and deicing chemicals. If concrete exposed to freeze thaw cycling is not properly air entrained, the durability of the concrete will be compromised and the service life of the structure will be shortened.

Quality Assurance 60

Quality Assurance Curing Quality Control Structural Systems 60

GCP Applied Technologies

MARCH 3, 2020

Replacing a certain percentage of Portland cement with fly ash imparts workability, allowing the concrete to be placed and finished more easily. Concrete is typically easier to place and finish with slumps greater than those either specified, designed, or both. Its primary benefits come from its durability and workability though.

Concrete Pouring 78

Concrete Pouring Wall Systems Quality Control Fire Protection System Installation 78

CivilJungle

JANUARY 29, 2022

Cast-in-situ concrete is prepared, placed, and finished on the construction site. are preferred structures in cast-in-situ concrete. This type of concrete is also finished on the site. are preferred structures in cast-in-situ concrete. Cast-in-situ concrete is prepared, placed, and finished on the construction site.

Concrete Pouring 52

Concrete Pouring Foundation Systems Wall Systems Curing 52

Civil + Structural Engineer

SEPTEMBER 1, 2023

This has driven the goal for many organizations to achieve net zero greenhouse gas emissions in their built structures—that is, to balance the amount of project-associated CO2 released into the atmosphere by removing an equivalent amount. We give them eyes on their concrete as it’s arriving and inside their concrete as it cures.

Building Materials Manufacturing 130

Building Materials Manufacturing Building Performance Measurement Building Materials Environmental Impact Assessment 130

CivilJungle

DECEMBER 25, 2021

By discrepancy, poured concrete driveways must cure for seven days before being used. The mid-layer provides structure, and the top subcaste is a pattern-resistant face that gives the asphalt its continuity. Hot mix asphalt refers to the operating system rather than the type of asphalt. What Is Asphalt Driveway ? Porous Asphalt.

Concrete Pouring 98

Concrete Pouring Painting/finishing Structural Systems Energy Conservation 98

GCP Applied Technologies

MARCH 21, 2018

According to a recent study by Allied Market Research, the demand for greater energy efficiency and faster construction is driving an increase in the use of precast concrete systems. Precast concrete is often used to create structural systems (columns, beams, floors, girders, etc.), Structural Solutions. Concera Blog #19.

Cost Control 60

Cost Control Structural Systems Building Controls Flooring Systems 60

Construction Specifier

JUNE 17, 2024

At the same time, the built environment must adapt to the impacts of an already-changing climate by optimizing the resiliency of structural systems. Model building codes (I-codes) developed by the International Code Council ( ICC ) play a crucial role in constructing safe, sustainable, and resilient structures.

Sustainability 105

Sustainability Building Resilience Environmental Impact Assessment Building Materials Manufacturing 105

CivilJungle

MARCH 13, 2021

Mass Concrete: Large bridge piers , foundations , and such as dams like the massive structure , the mass concreting technique is used. To prevent shrinkage, one must have excellent control of early setting the mass concrete intended for a large structure. The temperature shrinkage is the major problem in mass concrete work.

Concrete Pouring 52

Concrete Pouring Curing Foundation Systems Structural Systems 52

CivilJungle

JANUARY 16, 2021

Bamboo is widely used in the construction industry for various purposes such as scaffolding construction of bridges and structures etc. Bamboo is widely used for the construction of partition walls and beams which are the main structural elements of any structure. Hence, it is also known as structural bamboo.

Architecture 69

Architecture Building Materials Roofing Systems Material Handling 69

UK Construction Blog

JUNE 6, 2023

Ever wondered how concrete structures maintain their shape and strength during construction? As we dive into the various types of shuttering materials and techniques, prepare to be amazed by the innovative systems that enable complex and unique structures to come to life.

Steel Fabrication 52

Steel Fabrication Structural Systems Wall Systems Concrete Pouring 52

CivilJungle

JANUARY 12, 2021

Introduction of Pile Cap: The pile cap is a type of thick concrete mat-like structure which rests on the pile (timber or concrete) which gives a stable foundation to the whole system. The similar structure of the pile cap is a raft foundation, where there is also a concrete block -like structure is constructed.

Foundation Systems 52

Foundation Systems Painting/finishing Structural Systems Building Design 52

CivilJungle

DECEMBER 28, 2020

Sometimes this concrete frame is also called as a skeleton of this entire structure. In this structure, the vertical members, i.e. columns, carry the entire load of the building , so it’s the most important part of this type of construction. Precast concrete frame structures are used in one storey building. Cast in situ.

Concrete Pouring 52

Concrete Pouring Foundation Systems Structural Systems Wall Systems 52

CCR Magazine

DECEMBER 10, 2024

Its ability to distribute weight evenly across the floor prevents structural damage and extends the lifespan of the underlying concrete. Epoxy’s smooth, seamless finish eliminates cracks and crevices where grime might accumulate. Metallic epoxy systems Metallic epoxy systems offer a stunning visual appeal for commercial spaces.

Flooring Systems 52

Flooring Systems Heavy Equipment Manufacturing Concrete Pouring Curing 52

CivilJungle

FEBRUARY 12, 2021

If the appearance of the concrete surface is relevant, it is important to take care of the finishing surface of the shutter. It should be ensured that the steel fragments are eliminated as they rust and tamper with the final finish of the concrete. Deliver the recommended surface finish for the cast concrete portion.

Concrete Pouring 52

Concrete Pouring Painting/finishing Wall Systems Building Materials Manufacturing 52

CivilJungle

JUNE 28, 2020

Shear wall is a structural member used to resist lateral forces, i.e., parallel to the plane of the wall. • In other words, Shear walls are vertical elements of the horizontal force resisting system. Shear wall is a structural member in a reinforced concrete framed structure to resist lateral forces such as wind forces.

Wall Systems 52

Wall Systems Structural Systems Foundation Systems Building Standards 52

For Construction Pros

JUNE 18, 2025

Ana Juraga Jun 18, 2025 Cortec Corporation @Wirestock - stock.adobe.com Contractors are usually on the first line of defense when it comes to advising clients on the longevity and durability of their concrete structures. A protective coating creates a durable, easy-to-clean barrier.

Heavy Equipment Manufacturing 52

Heavy Equipment Manufacturing Flooring Systems Construction Equipment Building Materials Manufacturing 52

CivilJungle

APRIL 20, 2022

The Gypsum board is placed in the middle of the total structure and it is surrounded by two paper boards. It is a green coloured board with a wax finish over it for waterproofing. It is done to create the whole fireproofing system. Those boards are fixed with building structures with nails, screws or some adhesives.

Painting/finishing 52

Painting/finishing Ceiling Systems HVAC System Installation Piping Installation 52

UK Construction Blog

JANUARY 20, 2025

Quality control is another biggiemess it up, and you risk the whole structure. Rebar detailing plays a vital role in reinforcing concrete structures. Quality control ensures the longevity and safety of precast structures. This attention to detail helps prevent structural failures, keeping buildings safe and sound.

Building Information Modeling (BIM) 52

Building Information Modeling (BIM) Steel Fabrication Concrete Pouring Quality Control 52

CivilJungle

MARCH 17, 2021

The Frost wall or frost-protected wall structure is built to keep soil below the building against freezing to secure the foundations in freezing conditions. Any damage to the structural foundation would have an effect on the overall integrity of the construction. What Is Frost Wall? They are built deep beneath the frost line.

Wall Systems 52

Wall Systems Foundation Systems Structural Systems Concrete Pouring 52

CivilJungle

MAY 29, 2021

Concrete Screed Curing and Dimension: Before the installation of the ground, it’s necessary to check that the screed is correctly placed and cured. This proper curing will let to finish the shrinkages in it if any. During the curing cycles of concrete screed, they’re vulnerable to hygrometric shrinkage.

Concrete Pouring 52

Concrete Pouring Flooring Systems Piping Installation Curing 52

UK Construction Blog

MAY 12, 2024

However, traditional basement finishing methods often need to pay more attention to a critical first step – installing proper structural support. It provides a sturdy foundation for framing basement walls and finishing the space. Bench footing creates a robust structural base for a long-lasting basement transformation.

Concrete Pouring 52

Concrete Pouring Building Permits Building Code Compliance Piping Installation 52

UK Construction Blog

OCTOBER 26, 2023

These signs could indicate spalling brickwork, which can lead to structural damage and unwanted moisture ingress. Proactive repair can prevent aesthetic damage, structural damage, mold growth and safety hazards. This can create unsightly damage and weaken the overall structure of your brick walls.

Masonry 64

Masonry Maintenance Structural Systems Wall Systems 64